Geosynthetic Institute News

August 1st, 2017

Commentary on geosynthetic specifications One can only suspect that the first specification on a given manufactured material came along with or very shortly after the first manufactured product became available. It follows then that some 200 years later, manufactured geosynthetic materials should do likewise. In fact, so-called standards organizations have evolved by publishing the following […]

Read More Edit

International Geosynthetics Society North American Chapter News

June 1st, 2017

A busy Geotechnical Frontiers conference for IGS–NA The International Geosynthetics Society–North American (IGS–NA) Chapter annual meeting was held on March 14, 2017, at Geotechnical Frontiers in Orlando, Fla. Among the key items discussed at the meeting were the appointment of the 2017–2019 board of directors, winners of the IGS–NA photo contest, and the 2017 Educate […]

Read More Edit

Geosynthetics Materials Association News

June 1st, 2017

GMA honors Dr. Robert M. Koerner and Dr. George Koerner On March 14 in Orlando, Fla., the Geosynthetic Materials Association (GMA) hosted the inaugural Robert M. Koerner Award and Lecture Series. Established by GMA in 2016, the award and lecture series is given to an individual who has had a measurable impact on the geosynthetics […]

Read More Edit

Geosynthetics Institute News

June 1st, 2017

Robert M. Koerner on his namesake award and lecture series On March 14, 2017, at the Geotechnical Frontiers conference in Orlando, Fla., George Koerner graciously accepted the Robert M. Koerner Award and Lecture Series. The biennial award and lecture series were established by the Geosynthetic Materials Association (GMA) Executive Council; Koerner was the first recipient. […]

Read More Edit

Are zero leaks with installed geomembranes possible?

June 1st, 2017

Abigail Gilson-Beck and Glen Toepfer step into a geosynthetics minefield in this issue of Geosynthetics with their article “Achieving zero leaks on a budget,” a goal that is controversial in the industry. Whether this goal should even be an objective is the question the debate hinges on. A spirited discussion on this issue arose during […]

Read More Edit

In the classroom: Part 1: Learning about civil engineering technology

June 1st, 2017

Introduction This article is the first of a four-part series in Geosynthetics magazine on how an engineering student or practicing engineer is able to learn about geosynthetic materials. These articles are based on a panel discussion session on March 13, 2017, at the Geotechnical Frontiers conference in Orlando, Fla. Part 1 addresses the topic of […]

Read More Edit