TEXTILES.ORG
Your extrusion welding rod matters
May 3rd, 2022
Solmax discusses why choosing your extrusion welding rod matters, and the best ways to perform an extrusion weld on a geomembrane. Circular geomembrane extrusion weld. Photograph courtesy of Solmax Extrusion welding is a highly effective seaming method that’s primarily used for detailed patching work on polymeric geomembranes such as high-density polyethylene (HDPE) and linear low-density polyethylene (LLDPE). It also works well […]
The GMA Techline
August 1st, 2020
Seaming dissimilar geomembranes Q: I kindly request your technical support in the questions below: A nonpolyethylene geomembrane was used in phase 1 of the tailings dam waterproofing system of a gold mine. For the expansion (phase 2), the use of a high-density polyethylene (HDPE) geomembrane is being evaluated. How can the HDPE geomembrane join the bituminous […]
Lessons learned in alternative coal ash pond closure design and construction
October 1st, 2019
By Anna M. Saindon Coal ash pond closures often face unique challenges due to location, available borrow soils and construction constraints. These challenges can lead to alternative methods of closure to comply with Resource Conservation and Recovery Act (RCRA) Subtitle D and coal combustion residuals (CCR) regulations. This article summarizes the construction of the first […]
Don’t be afraid of making horizontal geomembrane seams on side slopes
August 1st, 2018
Over the years, there have been many discussions raising concerns about having geomembrane field seams located horizontally on side slopes. By not allowing such seams, it usually results in many short roll lengths that become either unused or difficult to tailor into the flat area of the project. Stated differently, the installation costs increase accordingly. […]
Reviving the Palos Verdes Reservoir—Part 2
April 1st, 2018
The October/November 2016 issue of Geosynthetics published Part 1 of this series on revitalizing the Palos Verdes Reservoir in Los Angeles County, California. That article described the approach to revitalizing the site, as well as the five-month-long geosynthetic manufacturing and fabrication phase. In Part 2, we continue to explore more of the inner workings for […]
GMA Techline
August 1st, 2017
Liner repair? Pullout tests? Sewn seams? Shear strength of sludges? Geomembrane liner repair Q: I have a facility that has submitted liner repair documentation for the repair of a high-density polyethylene (HDPE) liner for a leachate/stormwater pond at an industrial landfill site. The repairs were performed using either a patch or, for indentations and small […]