Found 908 results.
July 15, 2010
…text. The subgrade requirements for preventing water pressure buildup below a liner are also addressed in this guideline. This document is at: www.fabricatedgeomembrane.com For more information: +1 217-333-3929, geomembrane@illinois.edu…
July 1, 2010
…Eli Cuelho, Western Transportation Institute, Montana State University, Bozeman, Mont., +1 406 994 7886; elic@coe.montana.edu ASTM staff contact: Christine Basile, +1 610 832 9728, cbasile@astm.org For more information: www.astm.org…
June 17, 2010
…media representatives, and civil engineering professors were enthusiastic as the civil engineering faculty demonstrated how well modern geosynthetic reinforcement techniques can perform. See the video: www.naue.com/video-en For more information: info@NAUE.com;…
June 17, 2010
…crimped interlocking fibers. Micro-Pore particles optimize water and nutrient retention while increasing wet bond strength and increasing resistance to sheet flow, the press release stated. For more information: www.profileproducts.com…
May 14, 2010
…and new product opportunities. Thrace-LINQ is a supplier of woven and nonwoven polypropylene-based technical fabrics with its U.S. manufacturing and distribution center in Summerville, S.C. For more information: www.thracelinq.com….
May 13, 2010
…still be done at:www.geotec.coppe.ufrj.br/ssc2010 The OC would also like to mention that the subscription for only one day of the symposium is possible at a reduced rate. For the convenience…
May 4, 2010
…site. More information about the proposed regulation: http://www.epa.gov/coalashrule To view the chart comparing the two approaches: http://www.epa.gov/coalashrule/ccr-table.htm To view results of the impoundment assessments: http://www.epa.gov/epawaste/nonhaz/industrial/special/fossil/surveys2/index.htm CONTACT: Latisha Petteway petteway.latisha@epa.gov 202-564-3191…
April 1, 2010
…that would otherwise flow to the ocean. Board members backing the proposal say they hope the ordinance is approved this year and goes into effect by 2011. Source: WaterTechOnline…
April 1, 2010
…You also ask what would be an acceptable extrusion weld. If you go to our website at www.geosynthetic-institute.org under “specifications” and look at GRI-GM19 you will find that 1.5mm HDPE…
April 1, 2010
…Local Liaison Co-chairs Anand Puppala, University of Texas at Arlington Tom Taylor, T&B Structures International Liaison Chair Vern Schaefer, Iowa State University For more information about this event: www.geofrontiers11.com…
TEXTILES.ORG
