Zero cohesion

Geosynthetics | April 2011

Editor's Note: The question below was submitted regarding the Richard Thiel article "Cohesion (or adhesion) and friction angle in direct shear tests," from the April 2009 Geosynthetics.

Comment

From: Leo
Posted: Oct. 3, 2010 | 11:12 p.m.

What happens if you force the line of best fit through zero, to force a zero cohesion?

Reply

From: Richard Thiel, President, Thiel Engineering

Forcing the best fit  envelope through the origin is usually a conservative and accepted interpretation of the test results.  If this interpretation results in an inadequate definition of shear strength to demonstrate slope stability, then a more rigorous interpretation of the results may be in order. In general, a more rigorous interpretation that does not require a forced envelope through the origin should be allowed when requested.

Join the discussion

To post your thoughts on these comments, fill out the comment form on the bottom of the article "Cohesion (or adhesion) and friction angle in direct shear tests," or send your coments to editor Ron Bygness at rwbygness@ifai.com.

Comments and letters can contain opinions of individuals who are writing and do not necessarily reflect the views of Geosynthetics magazine or the Industrial Fabrics Association International.

Comments

There are not yet any comments.
You can submit a comment using the form below.